Electroplated Diamond & CBN Tools

Diamond Internal Grinding Wheels are suited for non ferrous materials such as Tungsten Carbide, Ceramics, Sapphire, Glass, Stones, Fibre Reinforced Plastics etc.CBN Internal Grinding Wheels are usually used for hard ferrous materials over 45 HRC such as High Carbon and High Carbon High Chrome Steels etc.

Available in sizes varying from 1.0 mm to 20 mm or as specified.

Grit Size: -
80 / 100 (Rough)
120 / 140 (Medium)
200 / 240 (Fine)
or as specified.

Request
Callback

Varun Udyog Diamond Saws are highly efficient in cutting hard materials such as carbides, ferro magnets, glass fibre, bakelite, glass ,hard plastics, brake lining etc.

Standard sizes of 4, 6, 8, 10, 12, 18, 20 inches are readily available in thickness from 0.4 mm to 3.0 mm or as specified.

Grit Size :-
80 / 100 (Rough)
120 / 140 (Medium)
200 /240 (Fine)
or as specified.

Request
Callback

A complete refurbishing and re-plating service is available for both standard and custom diamond tooling.Steel blanks in good condition can normally be re-plated.
Special process for coating on Aluminum, Stainless Steel, Carbide, etc.

Request
Callback

Diamond Files are offered in the form of Needle Files, Riffler Files, Diprofile Files and in the normal sizes. Machine files can also be supplied against customer's specifications.
Angle pins for sizing carbide dies are available in standard 9 x 6 mm (12°, 18°), 6 x 6 mm (6°) in rough, medium and fine grit sizes.

Shapes : Flat, Round, Triangle, Square, Half Round, Taper Flat, Knife

The standard sizes of the needle files are:-
160 mm Overall Length - 90 mm Coated Length
220 mm Overall Length - 110 mm Coated Length

Request
Callback